What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
13.06.2025 08:19

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
(Dc diagram shown, AC is similar).
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Barnstars:
If you believe in God, do you think God can save you from cancer?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
I post the exact comment here.
But it can get overloaded, and no longer works.
One
2024–10–10[John johnson John Johnson ]
He then describes the function of a fuse.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
In schematic diagrams this is the symbol for a fuse:
[image of Common-mode choke]
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
How do great movie moments influence how people handle real-life moral dilemmas?
At least they know the answer if they wanted it.
There are three different concepts here that are getting confused.
The MOV will conduct when the voltage exceeds 50% of line voltage.
What should I do if I love a girl and she apparently doesn't love me?
Upvotes:
An AC voltage/ current source, and an ac inductive load.
but I think this circuit , shows a few more pieces.
The third is lightning and “how it gets conducted into a home.”
First Sentence:
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Now when you have a certain ac resistance, then a current flows in a loop.
What’s one positive trait you’ve gained because of BPD?
He then describes Rainy Season and Lightning.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
These are simplified answers to the original question, and does not change anything I wrote above.
but this device (an Inductor) … impedes the rapid changes in the current.
This one hit behind the barn.
[old diagram got deleted by accident]
This is 'the assistant's answer'
What caused North Korea to go poor when at first it was rich?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
so, what happens?
eight
nine
2024–10–14 [Omar Gharbi Omar Gharbi ]
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
A circuit breaker is similar, but is resettable.
At one ohm, the resistor has a maximum of 1 watt power.
These devices are installed between the “hot” and “neutral” and protective ground.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
One is “what exactly is in a ‘surge protector’ ? ”
It seems Mohan does not understand the difference between a comment and an Answer.
Because the load is inductive, the current lags the voltage.(by a bit).
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
What does a fuse do?
This is where the MOV conducts again, and dissipated the energy.
He then asserts :
what exactly is a ‘surge’ protector?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–16 [ OO OLAOYE OYEBODE ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The other is “what does a “fuse” do?”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
What is lightning?
But… the neutral is now “floating” because of the 1 ohm resistance.
This device then solves the entire problem.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
A fuse is a non-resetable over current circuit protector.
The bolt then partially travels down the line to your home.
There are two important concepts here.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
a photo is worth a thousand words.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
the problem then depends on "how fast does the fuse operate?".
Here is a simplified AC power diagram.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Edit 2024–10.
This is where this question deviates from being a 'generic' question, and becomes more specific.
For this case there are devices called Metal oxide varistors (MOV).
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
It also is a device that limits the change in current flow.